AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

   
   

   1. Using SST, install the air fuel ratio sensor onto the exhaust manifold converter sub-assembly.

      SST

      09224-00010

      Torque:

      without SST

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      with SST

      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips

      
      

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values Click here.

2. INSTALL WIRE HARNESS CLAMP BRACKET

   
   

   1. Install the wire harness clamp bracket.

   2. Engage the 5 clamps and connect the wire harness to the wire harness clamp bracket.

   3. Connect the connector of the air fuel ratio sensor.

3. INSTALL NO. 2 ENGINE COVER BRACKET

   
   

   1. Install the No. 2 engine cover bracket with the 2 nuts.

      Torque:

      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

4. INSTALL OUTER COWL TOP PANEL

   Click here

5. INSTALL INNER COWL TOP TO COWL BRACE

   Click here

6. INSTALL FRONT NO. 1 VENTILATOR SEAL

   Click here

7. INSTALL FRONT AIR SHUTTER SEAL RH

   Click here

8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

9. INSPECT FOR EXHAUST GAS LEAK

10. INSTALL NO. 1 ENGINE COVER

    Click here