AIR FUEL RATIO SENSOR REMOVAL

PROCEDURE


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE FRONT NO. 1 VENTILATOR SEAL

    Click here

  3. REMOVE FRONT AIR SHUTTER SEAL RH

    Click here

  4. REMOVE INNER COWL TOP TO COWL BRACE

    Click here

  5. REMOVE OUTER COWL TOP PANEL

    Click here

  6. REMOVE NO. 1 ENGINE COVER

    Click here

  7. REMOVE NO. 2 ENGINE COVER BRACKET


    1. A01VJNQ

      Remove the 2 nuts and the No. 2 engine cover bracket.

  8. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01VHZW

      Disconnect the connector of the air fuel ratio sensor.

    2. Disengage the 5 clamps and disconnect the wire harness from the wire harness clamp bracket.

    3. Remove the wire harness clamp bracket.

  9. REMOVE AIR FUEL RATIO SENSOR


    1. A01VIH7E04

      Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.

      SST
      09224-00010

      Note

      If a component has been dropped or subjected to a strong impact, replace it.