INITIALIZATION
Note
If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (refer to the registration procedures for Service Bulletin).
Make sure to perform Reset Memory (CVT initialization), deceleration sensor 0 point calibration and CVT oil pressure calibration when replacing the ECM Click here.
Tech Tips
Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.
WHEN USING INTELLIGENT TESTER
CAUTION:
Observe the following items for safety reasons:
Read the intelligent tester instruction books before using the tester.
Make sure that the tester cable is not caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
When driving the vehicle for testing purposes while using the tester, 2 persons are required. One person drives the vehicle and the other operates the tester.
IGNITION SWITCH EXPRESSIONS
Tech Tips
The type of ignition switch used on this model differs according to the specifications of the vehicle.
The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition switch off | LOCK | Off |
| Ignition switch ON | ON | On (IG) |
| Ignition switch ACC | ACC | On (ACC) |
| Engine Start | START | Start |