REAR BRAKE(for Disc Type) INSPECTION

Click here Click here

PROCEDURE

1. Click here

   INSPECT PAD LINING THICKNESS

   
   

   1. Using a ruler, measure the pad lining thickness.

      Table 1. Text in Illustration

      *1

      Ruler

      Standard thickness
      9.0 mm (0.354 in.)

      Minimum thickness
      2.0 mm (0.079 in.)

      If the pad lining thickness is equal to the minimum thickness or less, replace the disc brake pad kit.

2. Click here

   INSPECT DISC THICKNESS

   
   

   1. Using a micrometer, measure the disc thickness.

      Table 2. Text in Illustration

      *1	Micrometer

      Standard thickness
      9.0 mm (0.354 in.)

      Minimum thickness
      7.0 mm (0.276 in.)

      If the disc thickness is less than the minimum, replace the rear disc.

3. Click here

   INSPECT DISC RUNOUT

   
   

   1. Check the bearing play in the axial direction and check for the axle hub runout (Click here).

   2. Provisionally fasten the rear disc together with the hub nuts.

      T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }

   3. 

      Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.

      Table 3. Text in Illustration

      *1	Dial Indicator

      Maximum disc runout
      0.15 mm (0.0059 in.)

      If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, grind the disc. If the disc thickness is less than the minimum, replace the rear disc.