REAR BRAKE(for Disc Type) REMOVAL

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DRAIN BRAKE FLUID

    Note

    Immediately wash off any brake fluid that comes into contact with any painted surfaces.

  3. DISCONNECT PARKING BRAKE CABLE ASSEMBLY

    A01VJTH

    1. Disconnect the cable end from the rear disc brake cylinder operation lever.

    2. Using needle-nose pliers, disengage the claws of the casing cap and disconnect the parking brake cable.

  4. SEPARATE REAR FLEXIBLE HOSE

    A01VFC3

    1. Remove the union bolt and gasket and separate the flexible hose from the disc brake cylinder.

  5. REMOVE REAR DISC BRAKE ANTI-RATTLE SPRING

    A01VHV9

    1. Remove the spring from the disc brake cylinder.

  6. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

    A01VJ3S

    1. Remove the 2 slide bolt caps.

    2. A01VIA5

      Using "TORX" socket wrench T45, remove the 2 slide bolts and remove the disc brake cylinder.

  7. REMOVE REAR DISC BRAKE PAD

    A01VFJH

    1. Remove the 2 disc brake pads from the disc brake cylinder mounting.

  8. REMOVE REAR DISC BRAKE BUSH DUST BOOT

    A01VF3O

    1. Remove the 2 dust boots from the disc brake cylinder.

  9. REMOVE REAR DISC BRAKE CYLINDER MOUNTING

    A01VK8T

    1. Remove the 2 bolts and remove the disc brake cylinder mounting from the axle beam.

  10. REMOVE REAR DISC

    A01VF0QE03
    Text in Illustration
    *a Matchmark

    1. Place matchmarks on the disc and axle hub and remove the disc.