REAR BRAKE FLEXIBLE HOSE INSTALLATION

PROCEDURE

1. INSTALL REAR BRAKE TUBE FLEXIBLE HOSE (for Rear Disc Brake)

   
   

   1. Install the flexible hose with a new union bolt and a new gasket.

      Torque:

      30 N*m  { 310 kgf*cm, 22 ft.*lbf }

      Tech Tips

      Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

   2. Install a new clip.

      Note

      Install the clip as far as it will go.

   3. Using a union nut wrench 10 mm, install the brake tube onto the flexible hose while holding the flexible hose with a wrench.

      Torque:

      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

2. INSTALL REAR FLEXIBLE HOSE

   
   

   1. Install the rear flexible hose with 2 new clips.

      Note

      Install the clip as far as it will go.

   2. Using a union nut wrench 10 mm, connect the 2 brake tubes to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:

      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

3. BLEED BRAKE LINE

   
   

   • for TMC Made Click here

   • for TMMF Made Click here

4. BLEED CLUTCH LINE (for Manual Transmission)

   
   

   • for 1KR-FE Click here

   • for 1NR-FE Click here

   • for 1ND-TV Click here

5. INSTALL REAR WHEEL

   Torque:

   103 N*m  { 1050 kgf*cm, 76 ft.*lbf }