BRAKE BOOSTER(for TMMF Made RHD) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

   Click here

2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

   Click here

3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

   Click here

4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

   Click here

5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

   Click here

6. REMOVE FRONT NO. 1 VENTILATOR SEAL

   
   

   1. 

      Disengage the clamp to remove the front No. 1 ventilator seal.

7. REMOVE FRONT AIR SHUTTER SEAL RH

   Tech Tips

   Use the same procedure as for the No. 1 ventilator seal.

8. REMOVE INNER COWL TOP TO COWL BRACE

   
   

   1. 

      Remove the 2 bolts and the inner cowl top to cowl brace.

9. REMOVE OUTER COWL TOP PANEL

   
   

   1. 

      Disengage the 2 clamps to separate the wire harness.

   2. Remove the 8 bolts and the outer cowl top panel.

      

10. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

    Click here

11. DISCONNECT VACUUM SENSOR CONNECTOR (w/ Vacuum Sensor)

    

    
    

    1. Disconnect the vacuum sensor connector.

12. REMOVE BRAKE BOOSTER ASSEMBLY

    
    

    1. 

       Separate the wire harness clamp.

    2. except 2NR-FKE:

       
       

       1. Slide the clip and disconnect the vacuum hose from the brake vacuum check valve assembly.

    3. 

       for 2NR-FKE, CVT:

       
       

       1. Slide the 2 clips and disconnect the 2 vacuum hoses from the 2 brake vacuum check valve assemblies.

    4. for 2NR-FKE, Manual Transaxle:

       
       

       1. 

          Slide the clip and disconnect the vacuum hose from the brake vacuum check valve assembly.

    5. 

       Separate the wire harness clamp and 4 nuts and remove the brake booster assembly.

       Note

       Do not damage the brake tubes.

    6. Remove the gasket from the brake booster assembly.