BRAKE BOOSTER(for TMMF Made RHD) REMOVAL

CAUTION / NOTICE / HINT

Note

Release the vacuum from booster by depressing the brake pedal several times.

Then remove the brake master cylinder from brake booster.

PROCEDURE


  1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

    Click here

  2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

    Click here

  3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

    Click here

  4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

    Click here

  5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  6. REMOVE FRONT NO. 1 VENTILATOR SEAL

    Click here

  7. REMOVE FRONT AIR SHUTTER SEAL RH

    Click here

  8. REMOVE INNER COWL TOP TO COWL BRACE

    Click here

  9. REMOVE OUTER COWL TOP PANEL

    Click here

  10. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

    Click here

  11. DISCONNECT VACUUM SENSOR CONNECTOR (w/ Stop And Start System)

    A01VICH

    1. Disconnect the vacuum sensor connector.

  12. REMOVE BRAKE BOOSTER ASSEMBLY

    A01VLPT

    1. Slide the clip and disconnect the vacuum hose from the check valve.

    2. Separate the wire harness clamp.

    3. A01VG9R

      Separate the wire harness clamp and 4 nuts and remove the brake booster assembly.

      Note

      Do not damage the brake tubes.

    4. Remove the gasket from the brake booster assembly.