BRAKE BOOSTER(for TMMF Made RHD) INSTALLATION

PROCEDURE

1. INSTALL BRAKE BOOSTER ASSEMBLY

   
   

   1. Install a new gasket onto the brake booster assembly.

   2. Temporary install the brake booster assembly with the 4 nuts.

   3. 

      Tighten the 4 nuts as shown in the illustration.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

   4. Install the wire harness clamp.

   5. Connect the vacuum hose to the vacuum check valve with the clip.

2. INSTALL VACUUM SENSOR CONNECTOR

   
   

   1. Connect the vacuum sensor connector.

3. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

   Click here

4. INSTALL OUTER COWL TOP PANEL

   Click here

5. INSTALL INNER COWL TOP TO COWL BRACE

   Click here

6. INSTALL FRONT NO. 1 VENTILATOR SEAL

   Click here

7. INSTALL FRONT AIR SHUTTER SEAL RH

   Click here

8. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

   Click here

9. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

   Click here

10. INSPECT AND ADJUST BRAKE PEDAL HEIGHT

    Click here

11. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

    Click here

12. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

    Click here

13. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)