Click here

BRAKE FLUID(for TMMF Made) REPLACEMENT

Click here
Click here

CAUTION / NOTICE / HINT

Note:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.

Tip:

If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the system.

Click here

PROCEDURE


  1. Click here

    REMOVE CENTER COWL TOP VENTILATOR LOUVER (for LHD)

    Click here

  2. Click here

    REMOVE CENTER COWL TOP VENTILATOR LOUVER (for RHD)

    Click here

  3. Click here

    FILL RESERVOIR WITH BRAKE FLUID

    Click here

  4. Click here

    REPLACE BRAKE FLUID


    1. A01VHM7

      Connect a vinyl tube to the bleeder plug.

    2. Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed (Step C).

    3. At the point where the fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (Step D).

    4. Repeat Steps C and D until the new brake fluid is comes out.

    5. Tighten the bleeder plug.

      Front Brake
      17 N*m 173 kgf*cm 13 ft.*lbf
      Rear Brake (for Rear Disc Brake)
      14 N*m 143 kgf*cm 10 ft.*lbf
      Rear Brake (for Rear Drum Brake)
      9.5 N*m 97 kgf*cm 84 in.*lbf

    6. Repeat the above procedure to bleed the air out of the brake line for each wheel.

  5. Click here

    INSPECT FOR BRAKE FLUID LEAK

  6. Click here

    INSPECT FLUID LEVEL

    Click here

  7. Click here

    INSTALL CENTER COWL TOP VENTILATOR LOUVER (for LHD)

    Click here

  8. Click here

    INSTALL CENTER COWL TOP VENTILATOR LOUVER (for RHD)

    Click here