BRAKE MASTER CYLINDER(for TMMF Made RHD) INSTALLATION

PROCEDURE

1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o VSC)

   
   

   1. Install a new O-ring onto the brake master cylinder sub-assembly.

   2. Install the brake master cylinder sub-assembly with the 2 new nuts.

      Torque:

      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

   3. Using a union nut wrench, install the 2 brake tubes onto the brake master cylinder sub-assembly.

      Torque:

      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

   4. Connect the brake fluid level warning switch connector.

2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ VSC)

   
   

   1. Install a new O-ring onto the brake master cylinder sub-assembly.

   2. Install the brake master cylinder sub-assembly with the 2 new nuts.

      Torque:

      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

   3. Using a union nut wrench, install the 2 brake tubes onto the brake master cylinder sub-assembly.

      Torque:

      20 N*m  { 199 kgf*cm, 14 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

   4. Connect the brake fluid level warning switch connector.

3. INSTALL CLUTCH RESERVOIR TUBE

   
   

   1. Connect the clutch reservoir tube with the clip.

4. BLEED BRAKE LINE

   Click here

5. BLEED CLUTCH LINE (for Manual Transaxle)

   for 1KR-FE Click here

   for 1NR-FE Click here

   for 1ND-TV Click here