STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page SUPPLEMENTAL RESTRAINT SYSTEMS > AIRBAG SYSTEM (w/ VSC) > PRECAUTION).

PROCEDURE


  1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Check that the ignition switch is turned off.

    2. Check that the negative battery terminal is detached.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Check that the front tires face straight forward.

    4. Check that the turn signal switch is in the neutral position.

      Note

      Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.

    5. Engage the 3 claws and install the spiral cable with sensor sub-assembly.

      Note

      Pull the lock pin out before installing the steering wheel when replacing the spiral cable with sensor sub-assembly with a new one.

    6. Connect the steering sensor connector.

    7. Connect the airbag connector.

    8. Connect each connector to the spiral with sensor cable sub-assembly.

  2. INSTALL UPPER STEERING COLUMN COVER

    Click here

  3. INSTALL LOWER STEERING COLUMN COVER

    Click here

  4. INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

    Click here

  5. ADJUST SPIRAL CABLE

    Click here

  6. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  8. CHECK SRS WARNING LIGHT

    Click here