BRAKE ACTUATOR(for TMMF Made LHD) ON-VEHICLE INSPECTION

PROCEDURE


  1. CONNECT INTELLIGENT TESTER


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the intelligent tester on.

    6. Enter the following menus: Chassis / ABS/VSC/ TRC / Active Test.

      Tech Tips

      Refer to the intelligent tester Operator's Manual for further details.

  2. INSPECT ACTUATOR MOTOR OPERATION

    Note

    Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, set an interval of more than 20 seconds between operations.


    1. Enter the following menus: Active Test / Motor Relay.

    2. Turn the motor relay on and check for the actuator motor operation sound.

    3. Turn the motor relay off.

    4. Fully depress the brake pedal and hold it for approximately 15 seconds. Check that the pedal's initial depth is maintained for the entire 15 seconds.

    5. Turn the motor relay on and check that the pedal does not pulsate.

    6. Turn the motor relay off and release the brake pedal.

  3. INSPECT RIGHT FRONT WHEEL OPERATION

    Note

    Do not turn on a solenoid in a manner different from that shown in the following steps.


    1. Enter the following menus: Active Test / ABS Solenoid (SFRH) and ABS Solenoid (SFRR).

    2. Depress the brake pedal and hold it.

    3. Turn the SFRH and SFRR solenoids on simultaneously and check that the pedal cannot be depressed.

      Note

      Each solenoid operates for 2 seconds and turns off automatically. If it needs to be operated repeatedly, set an interval of more than 20 seconds between operations.

    4. Turn the SFRH and SFRR solenoids off simultaneously and check that the pedal can be depressed.

    5. Turn the motor relay on and check that the pedal returns.

      Note

      Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, set an interval of more than 20 seconds between operations.

    6. Turn the motor relay off and release the brake pedal.

  4. INSPECT OTHER WHEEL OPERATION


    1. Using the same procedure, check the solenoids of the other wheels.

      Tech Tips


      • Left front wheel: SFLH, SFLR

      • Right rear wheel: SRRH, SRRR

      • Left rear wheel: SRLH, SRLR