Click here

VEHICLE STABILITY CONTROL SYSTEM(for TMMF Made) HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here Click here
DTC Code DTC Name
  HOW TO PROCEED WITH TROUBLESHOOTING
Click here

CAUTION / NOTICE / HINT

Tip:

  • The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.

  • *: Use the intelligent tester.

Click here

PROCEDURE


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

  2. Click here

    CUSTOMER PROBLEM ANALYSIS


    1. Interview the customer and confirm the trouble.

      Click here

      Result
      Proceed to
      NEXT

  3. Click here

    CHECK DTC AND FREEZE FRAME DATA*


    1. Check and record DTC and Freeze Frame Data.

    2. Clear the DTC and Freeze Frame Data (Click here for DTC Check/Clear, orClick herefor Freeze Frame Data).

    3. Reconfirm the DTC.


      1. Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (Click here for DTC Check/Clear, orClick herefor Freeze Frame Data).

        Tip:

        If any of the DTCs U0073, U0100, U0123, and U0126 are output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit.

        Click here

      Result
      Result Proceed to
      DTC is output A
      DTC is not output (Problem symptom does not occur) B
      DTC is not output (Problem symptom occurs) C

  4. Click here

    DIAGNOSTIC TROUBLE CODE CHART


    1. Proceed to Diagnostic Trouble Code Chart.

      Click here

      Result
      Proceed to
      NEXT

  5. Click here

    SYMPTOM SIMULATION


    1. Proceed to Check for Intermittent Problems.

      Click here

      Result
      Proceed to
      NEXT

  6. Click here

    PROBLEM SYMPTOMS TABLE


    1. Proceed to Problem Symptoms Table.

      Click here

      Result
      Proceed to
      NEXT

  7. Click here

    CIRCUIT INSPECTION*

    Result
    Proceed to
    NEXT

  8. Click here

    IDENTIFICATION OF PROBLEM

    Result
    Proceed to
    NEXT

  9. Click here

    REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

  10. Click here

    CONFIRMATION TEST*

    Result
    Proceed to
    NEXT

    • NEXT

      END