HEATED OXYGEN SENSOR(for Sensor 2) INSTALLATION

PROCEDURE

1. INSTALL NO. 2 HEATED OXYGEN SENSOR

   
   

   1. Using SST, install the No. 2 heated oxygen sensor onto the front exhaust pipe assembly.

      SST

      09224-00010

      Torque:

      without SST

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      with SST

      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips

      
      

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values Click here.

   2. Engage the 3 clamps and connect the No. 2 heated oxygen sensor wire to the fan shroud.

   3. Connect the connector of the No. 2 heated oxygen sensor.

2. INSPECT FOR EXHAUST GAS LEAK