HEATED OXYGEN SENSOR(for Sensor 1) INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. A0047TPE02
      Text in Illustration
      *a Fulcrum Length of SST
      *b Fulcrum Length of Torque Wrench

      Using SST, install the heated oxygen sensor onto the exhaust manifold.

      SST
      09224-00010
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 40 N*m (408 kgf*cm, 30 ft.*lbf).

    2. Engage the 2 clamps to connect the heated oxygen sensor wire to the wire harness clamp bracket.

    3. Connect the heated oxygen sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK