MANIFOLD ABSOLUTE PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

   
   

   1. Install the manifold absolute pressure sensor onto the intake manifold sub-assembly with the 2 bolts.

      Torque:

      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      
      

      • If reusing the manifold absolute pressure sensor, be sure to inspect the O-ring.

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

   2. Connect the connector of the manifold absolute pressure sensor.

2. INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY

   Click here