KNOCK SENSOR INSTALLATION

PROCEDURE


  1. INSTALL KNOCK SENSOR


    1. A01VK7FE05
      Text in Illustration
      *a Upper

      Install the knock sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • If a component has been dropped or subjected to a strong impact, replace the knock sensor.

      • Make sure that each knock sensor is in the correct position.

    2. Connect the knock sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here