ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DRAIN ENGINE COOLANT

    Click here

  4. REMOVE BATTERY

    Click here

  5. REMOVE BATTERY TRAY

    Click here

  6. REMOVE THERMOSTAT

    Click here

  7. DISCONNECT NO. 1 RADIATOR HOSE

    Click here

  8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B004725

      Disconnect the engine coolant temperature sensor connector.

    2. B0047C3

      Using a 19 mm union nut wrench, remove the engine coolant temperature sensor and gasket from the cylinder head sub-assembly.

      Note

      If a component has been dropped or subjected to a strong impact, replace engine coolant temperature sensor.