CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. B0047NH

      Apply a light coat of engine oil to the O-ring.

      Note

      If reusing the camshaft position sensor, be sure to inspect the O-ring.

    2. Install the camshaft position sensor to the cylinder head sub-assembly with the bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the camshaft position sensor connector.

  2. INSTALL BATTERY TRAY

    Click here

  3. INSTALL BATTERY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSPECT FOR ENGINE OIL LEAK


    1. Start the engine and check that there are no oil leaks.