THROTTLE BODY ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY

   
   

   1. Turn the ignition switch to ON without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

   2. Connect the intelligent tester to the DLC3 and clear the DTCs Click here.

   3. Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

      Standard
      Condition Engine Idle Speed A/C switched off 730 to 830 rpm

      Note

      
      

      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in N or P.

   4. Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Pos. Sensor Output.

   5. Fully depress the accelerator pedal and check that the value is 60% or more.

   6. Perform a road test and confirm that there are no abnormalities.