Click here

AHS ECU INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Note:

  • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.

  • Do not reuse parts which have reduced fastening ability due to thread damage.

  • When installing components, make sure that the wire harness is not pinched or pulled.

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL LIGHT CONTROL LED ECU LH

    Note:

    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • Perform work using clean rubber gloves.

    • Do not touch the light control LED ECU connector with bare hands.

    • Do not allow metallic surfaces to become dirty, as such surfaces become damaged even if they are only lightly wiped with a soft cloth.

    • If there are fingerprints on the inner surface of the lens, lightly wipe with a soft cloth.

    • Do not use solvent to clean components. Only clean them with a dry cloth.

    09890-47010 09891-04010 09891-04020 09891-04030 09891-04040

    1. B004WZV

      Install the light control LED ECU with the 2 screws.

    2. Connect the 2 connectors.

    3. B004RQ1

      Attach the wire harness clamp.

  2. Click here

    INSTALL NO. 1 HEADLIGHT CLEARANCE LED UNIT LH

    Click here

  3. Click here

    INSTALL HEADLIGHT LENS GASKET

    Click here

  4. Click here

    INSTALL HEADLIGHT LENS LH

    Click here

  5. Click here

    INSTALL HEADLIGHT ASSEMBLY LH

    Click here