ILLUMINATION LIGHT ASSEMBLY(for Rear Door) INSPECTION

PROCEDURE

1. Click here

   INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

   
   
   1. 

      *a	Component without harness connected (Rear Door Outside Handle Assembly LH)

      Apply 6.0 V (4 dry cell batteries in series) to the connector and check the illumination conditions.

      Note:

      Do not apply more than 6.0 V.

      OK
      Tester Connection Specified Condition K5-1 (OLP) - Dry cell battery positive (+) K5-3 (GND) - Dry cell battery negative (-) Illuminates If the result is not as specified, replace the rear door outside handle assembly LH.

2. Click here

   INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY RH

   
   
   1. 

      *a	Component without harness connected (Rear Door Outside Handle Assembly RH)

      Apply 6.0 V (4 dry cell batteries in series) to the connector and check the illumination conditions.

      Note:

      Do not apply more than 6.0 V.

      OK
      Tester Connection Specified Condition K19-1 (OLP) - Dry cell battery positive (+) K19-3 (GND) - Dry cell battery negative (-) Illuminates If the result is not as specified, replace the rear door outside handle assembly RH.