Click here

REAR LIGHT ASSEMBLY REASSEMBLY

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL REAR LIGHT END RUBBER


    1. B004REPC01
      B004VGX Area to Clean

      Clean the application area of the rear light end rubber shown in the illustration.

      Note:

      Remove any remaining double-sided tape, and then clean and degrease the area.

    2. Remove approximately 30 mm (1.18 in.) of the peeling tape from a new rear light end rubber.

    3. B004R1QC01
      *a Application Start Position - -

      Align the rear light end rubber with the application start position and set it.

    4. B004VRGC01
      B004RMI Install in this Direction

      While peeling the peeling tape, align the rear light end rubber to the curve and set it.

    5. B004SRJC01
      B004RMI Press Here

      Press the set portion of the part with your finger to secure it.

      Note:

      Do not slide your finger horizontally, as doing so may stretch the part unnecessarily.

  2. Click here

    INSTALL REAR LIGHT LED


    1. B004RFSC01
      B004RMI Clockwise

      Set the rear light LED into place and turn it clockwise until it stops to install it.

    2. B004SAA

      Install the screw.

    3. Connect the connector.

  3. Click here

    INSTALL REAR LIGHT GASKET


    1. B004W6T

      Install a new rear light gasket.

  4. Click here

    INSTALL REAR LIGHT GASKET LH


    1. B004XCN

      Install a new rear light gasket LH.

  5. Click here

    INSTALL REAR LIGHT PACKING LH


    1. B004Y7M

      Install a new rear light packing LH.