Click here

HEADLIGHT ASSEMBLY PRECAUTION

Click here
Click here Click here
Note:

When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).


Click here
  1. B004U7AN01

    STATIC ELECTRICITY COUNTERMEASURES SST

    SST:Desktop antistatic mat set (09890-47010)


    • Wristband

      SST
      09891-04020

    • Wristband connection wire (No. 1 grounding wire)

      SST
      09891-04030

    • Antistatic mat

      SST
      09891-04010

    • Ground connection wire (No. 2 grounding wire)

      SST
      09891-04040

  2. PRECAUTIONS DURING REPLACEMENT


    1. Precautions during procedures:


      1. Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.

      2. To prevent damage to an electrical equipment, disconnect the battery power supply before installing and removing the electrical equipment.

      3. Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.

      4. When performing procedures, do not allow clothing to come near or contact parts.

    2. B004U7AN01

      Wear SST (wristband) firmly on your wrist.

      SST
      09891-04020

    3. Connect SST (No. 2 grounding wire) and SST (antistatic mat) to an appropriate grounding point in the workspace and on the work table.

      SST
      09891-04040
      09891-04010
      B004SEL
      Tip:

      When working inside the vehicle:

      Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.

    4. Connect SST (No. 1 grounding wire), SST (wristband) and SST (antistatic mat).

      SST
      09891-04030

    5. Always place the headlight assembly and its components on SST (antistatic mat).