HEADLIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL HEADLIGHT ASSEMBLY LH

   
   

   1. 

      	Set to the Vehicle
      	Place Hands Here

      Set the headlight assembly LH to the vehicle.

   2. Place your hand on 2 brackets of the headlight assembly LH to set them on the screw seats.

      Note

      Be careful not to break the bracket.

   3. 

      Install the 3 screws and 2 bolts.

      Torque:

      for Bolt

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

   4. 

      *A	w/ Front Side Radar

      Connect the connector and lock the connector lock lever.

   5. w/ Front Side Radar:

      Connect the connector and attach the wire harness clamp.

2. INSTALL FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP LH

   
   
   1. 

      *a	Headlight Assembly LH Clip Installation Area

      Set the front fender reinforcement sub-assembly top LH and attach the clip.

      Note

      When attaching the headlight assembly LH to the clips, do not damage the clip installation area.

   2. Lower the rear end of the front fender reinforcement sub-assembly top LH and attach the hook toward the outside of the vehicle.

      

      Lower

      Attach the hook

   3. Attach the claw of the seal of the cowl top ventilator louver sub-assembly.

      

   4. Lower the end of the front fender reinforcement sub-assembly top LH and attach the hook toward the outside of the vehicle.

      

      Lower

      Attach the hook

3. INSTALL FRONT BUMPER ASSEMBLY

   except Sports Package:

   Click here

   for Sports Package:

   Click here

4. PERFORM REGISTRATION (When Replacing The Headlight Assembly LH or Headlight ECU Sub-assembly LH)

   Note

   
   

   • If any of the work in the table below has been performed, vehicle information registration of the headlight ECU sub-assembly LH is necessary.

     Click here

     Performed Work or System Condition	Necessary Procedures
     Replacement of the headlight ECU sub-assembly LH	Vehicle information registration for the headlight ECU sub-assembly LH
     Replacement of the headlight assembly LH

   • If the steering sensor zero point calibration is not performed, the cornering lights may not operate correctly.

   • A new headlight ECU sub-assembly LH cannot operate until the vehicle information is synchronized.

   • After replacing the headlight ECU sub-assembly LH, it is necessary to synchronize the vehicle information and performing initialization.

   • Even if the headlight ECU sub-assembly RH is replaced with a new one, synchronizing the vehicle information and performing initialization are not necessary.

   • Adjust the headlight aim after initializing the headlight ECU sub-assembly LH.

   • When a malfunction is detected in the automatic headlight beam level control system, rear height control sensor sub-assembly LH signal initialization is impossible. Perform troubleshooting before initialization.

5. PERFORM SYSTEM CALIBRATION

   Click here

6. ADJUST HEADLIGHT AIMING

   Click here