WIPER SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the RH side.

PROCEDURE


  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS

    Click here

  2. REMOVE LOWER STEERING COLUMN COVER

    Note

    If the removal procedures are followed incorrectly, the part may become damaged.


    1. B004SG2

      Turn the steering wheel assembly 90° to the right from the straight condition and remove the screw shown in the illustration.

    2. B004WHQ

      Turn the steering wheel assembly 90° to the left from the straight condition and remove the screw shown in the illustration.

    3. B004T6N

      Remove the screw.

    4. B004U4NC01
      B004RMI Push in this Direction

      Push from both left and right sides to detach the claw as shown in the illustration.

    5. B004YK7

      Detach the claw.

    6. B004RKDC01
      B004RMI Remove in this Direction

      Pull in the direction of the arrow shown in the illustration and remove the lower steering column cover, taking care not to catch the tilt and telescopic switch.

  3. REMOVE UPPER STEERING COLUMN COVER


    1. B004S3EC01
      B004RMI Remove in this Direction

      Detach the claw and disconnect the upper steering column cover.

    2. B004T5E

      Detach the clip and remove the upper steering column cover from the meter hood spacer.

  4. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. B004SQPC01
      B004RMI Remove in this Direction
      B004VGX Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, detach the claw and remove the windshield wiper switch assembly.

      Note

      Do not damage the claw.