Click here

REAR SEAT INNER BELT ASSEMBLY(for Fixed Seat Type) INSPECTION

Click here
Click here

PROCEDURE


  1. Click here

    INSPECT REAR SEAT INNER BELT ASSEMBLY LH


    1. B004U7ZC04
      *a

      Component without harness connected

      (Rear Seat Inner Belt Assembly LH)

      Check the buckle switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        L92-3 (+) - L92-4 (LBR-) Seat belt fastened (Buckle switch is on) Below 1 Ω
        L92-4 (LBR-) - L92-5 (+) Seat belt fastened (Buckle switch is on) 10 kΩ or higher
        L92-4 (LBR-) - L92-5 (+) Seat belt unfastened (Buckle switch is off) Below 1 Ω
        L92-3 (+) - L92-4 (LBR-) Seat belt unfastened (Buckle switch is off) 10 kΩ or higher
        If the result is not as specified, replace the rear seat inner belt assembly LH.

      2. Apply auxiliary battery voltage to the connector and check the LED illumination conditions.

        OK
        Tester Connection Specified Condition

        L92-1 - Auxiliary battery positive (+)

        L92-2 - Auxiliary battery negative (-)

        		 Buckle switch LED illuminates
        If the result is not as specified, replace the rear seat inner belt assembly LH.
  2. Click here

    INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH


    1. B004VKIC03
      *a

      Component without harness connected

      (Rear Seat Inner with Center Belt Assembly RH)

      Check the buckle switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        L91-2 (+) - L91-3 (RBR-) Seat belt fastened (Buckle switch RH is on) Below 1 Ω
        L91-3 (RBR-) - L91-4 (+) Seat belt fastened (Buckle switch RH is on) 10 kΩ or higher
        L91-3 (RBR-) - L91-4 (+) Seat belt unfastened (Buckle switch RH is off) Below 1 Ω
        L91-2 (+) - L91-3 (RBR-) Seat belt unfastened (Buckle switch RH is off) 10 kΩ or higher
        L91-6 (CBR-) - L91-7 (+) Seat belt fastened (Buckle switch center is on) 10 kΩ or higher
        L91-6 (CBR-) - L91-7 (+) Seat belt unfastened (Buckle switch center is off) Below 1 Ω
        If the result is not as specified, replace the rear seat inner with center belt assembly RH.

      2. Apply auxiliary battery voltage to the connector and check the LED illumination conditions.

        OK
        Tester Connection Specified Condition

        L91-8 - Auxiliary battery positive (+)

        L91-1 - Auxiliary battery negative (-)

        		 Buckle switch LED illuminates
        If the result is not as specified, replace the rear seat inner with center belt assembly RH.