POWER SEAT SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front power seat switch assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Stereo Camera type: Click here for Mono Camera type: Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Mono camera type)
		Pre-collision system (for Stereo camera type)
		Adaptive high beam system
		Lighting system (EXT) cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Power seat switch LH (Including removal and installation) Power seat switch RH (Including removal and installation)	Initialize position control ECU	Front Power Seat Control System	Click here
for Front Passenger Side with Occupant Detection System: Front seat assembly RH (Only for removal and installation) Occupant detection ECU (Including removal and installation)	Zero point calibration (Occupant classification system)	Occupant classification system Passenger airbag ON/OFF indicator Airbag system (Front passenger side) Seat belt warning system (Front passenger)	Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.

Note

If the front seat airbag assembly LH was deployed, replace the front seat airbag assembly LH, front seatback frame sub-assembly LH, separate type front seatback pad, separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

REMOVE FRONT SEAT ASSEMBLY

Click here
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

Click here
REMOVE RECLINING POWER SEAT SWITCH KNOB

Click here
REMOVE FRONT POWER ADJUSTER SHIELD LH

Click here
REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET LH

Click here
REMOVE BEZEL SWITCH HOLE COVER

Click here
REMOVE FRONT POWER SEAT SWITCH ASSEMBLY LH
1. Remove the 3 screws and front power seat switch assembly LH.