PEDESTRIAN PROTECTION SYSTEM CHECK MODE PROCEDURE


  1. CHECK MODE: DTC CHECK


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Select "Check Mode" and proceed with checking using the GTS.


      Body Electrical > Pedestrian Protection > Utility
      Tester Display
      Check Mode

      Note

      Select Signal Check on the GTS to clear the DTCs (both current and history).

      Tech Tips


      • DTCs can be detected more sensitively in check mode than in normal diagnosis mode.

      • Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.