TRIP SWITCH INSPECTION

PROCEDURE


  1. INSPECT TRIP SWITCH


    1. B004U3FC01
      *1 ODO TRIP Switch
      *a

      Component without harness connected

      (Trip Switch)

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        G8-4 (A/B) - G8-7 (E) ODO TRIP Switch pressed Below 1 Ω
        G8-4 (A/B) - G8-7 (E) ODO TRIP switch not pressed 10 kΩ or higher

        If the result is not as specified, replace the trip switch.

    2. B004U3FC05
      *a

      Component without harness connected

      (Trip Switch)

      Check illumination.


      1. Apply auxiliary battery voltage to the trip switch and check that it illuminates.

        OK
        Tester Connection Specified Condition

        G8-3 (ILL+) - Auxiliary battery positive (+)

        G8-8 (ILL-) - Auxiliary battery negative (-)

        		 Illuminates

        If the result is not as specified, replace the trip switch.