ROOM LIGHT INSPECTION

PROCEDURE


  1. INSPECT SPOT LIGHT ASSEMBLY


    1. Inspect the spot light assembly.


      1. B004T1QC01
        *a

        Component without harness connected

        (Spot Light Assembly)

        Inspect rear dome light.

        Apply auxiliary battery voltage to the connector and check the light illumination condition.

        OK
        Tester Connection Switch Condition Specified Condition

        N3-6 (B) - Auxiliary battery positive (+)

        N3-1 (E1) - Auxiliary battery negative (-)

        		 Dome light switch ON Dome light illuminates

        If the result is not as specified, replace the spot light assembly.

      2. B004T1QC02
        *a

        Component without harness connected

        (Spot Light Assembly)

        Inspect reading light.

        Apply auxiliary battery voltage to the connector and check the light illumination condition.

        OK
        Tester Connection Switch Condition Specified Condition

        N3-6 (B) - Auxiliary battery positive (+)

        N3-7 (E) - Auxiliary battery negative (-)

        		 Reading light switch LH ON Spot light LH illuminates

        N3-6 (B) - Auxiliary battery positive (+)

        N3-8 (E) - Auxiliary battery negative (-)

        		 Reading light switch RH ON Spot light RH illuminates

        If the result is not as specified, replace the spot light assembly.

      3. B004T1QC03
        *a

        Component without harness connected

        (Spot Light Assembly)

        Inspect switch illumination.

        Apply auxiliary battery voltage to the connector and check the light illumination condition.

        OK
        Tester Connection Specified Condition

        N3-5 (ILL+) - Auxiliary battery positive (+)

        N3-2 (ILL-) - Auxiliary battery negative (-)

        		 Switch illumination illuminates

        If the result is not as specified, replace the spot light assembly.