Click here

LIGHTING SYSTEM DATA LIST / ACTIVE TEST

Click here
Click here
Click here

  1. DATA LIST

    Note:

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      1. Body Electrical > Main Body > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        ACC SW Power switch on (ACC) signal OFF or ON

        ON: Power switch on (ACC)

        OFF: Power switch off

        		 "ON" is also displayed for this item when the power switch is on (IG).
        IG SW Power switch on (IG) signal OFF or ON

        ON: Power switch on (IG)

        OFF: Power switch off

        		 "OFF" is also displayed for this item when the power switch is on (ACC).
        RR Door Courtesy SW Rear door courtesy light switch assembly RH signal OFF or ON

        OFF: Rear door RH closed

        ON: Rear door RH open

        		 -
        RL Door Courtesy SW Rear door courtesy light switch assembly LH signal OFF or ON

        OFF: Rear door LH closed

        ON: Rear door LH open

        		 -
        FR Door Lock Pos Front door RH unlock detection switch signal LOCK or UNLOCK

        LOCK: Front door RH locked

        UNLOCK: Front door RH unlocked

        		 -
        FR Door Courtesy SW Front door courtesy light switch assembly RH signal OFF or ON

        OFF: Front door RH closed

        ON: Front door RH open

        		 -
        FL Door Lock Pos Front door LH unlock detection switch signal LOCK or UNLOCK

        LOCK: Front door LH locked

        UNLOCK: Front door LH unlocked

        		 -
        FL Door Courtesy SW Front door courtesy light switch assembly LH signal OFF or ON

        OFF: Front door LH closed

        ON: Front door LH open

        		 -
        Dome Light DOOR SW Map light sub-assembly (door switch) signal OFF or ON

        OFF: Map light sub-assembly (door switch) off

        ON: Map light sub-assembly (door switch) on

        		 -
        Dome Light SW Map light sub-assembly (room light switch) signal OFF or ON

        OFF: Map light sub-assembly (room light switch) off

        ON: Map light sub-assembly (room light switch) on

        		 -
        RR-Door Lock Pos SW Rear door RH unlock detection switch signal OFF or ON

        OFF: Rear door RH unlocked

        ON: Rear door RH locked

        		 -
        RL-Door Lock Pos SW Rear door LH unlock detection switch signal OFF or ON

        OFF: Rear door LH unlocked

        ON: Rear door LH locked

        		 -
        Rear Room Light Switch Spot light assembly (door switch) signal OFF or ON

        OFF: Spot light assembly (door switch) off

        ON: Spot light assembly (door switch) on

        		 -














  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus:


      1. Body Electrical / Main Body / Active Test.

      2. Body Electrical / Front Left Door / Active Test.

      3. Body Electrical / Front Right Door / Active Test.

      4. Body Electrical / Rear Left Door / Active Test.

      5. Body Electrical / Rear Right Door / Active Test.

      6. Body Electrical / Rear Left Seat / Active Test.

      7. Body Electrical / Rear Right Seat / Active Test.

      8. Body Electrical / Entry&Start/ Active Test.

    5. Perform the Active Test according to the display on the GTS.


      1. Body Electrical > Main Body > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Illuminated Entry System Turns on the lights that are controlled by the illuminated entry system* OFF or ON Perform the Active Test with DOOR switch in the map light sub-assembly and spot light assembly turned on.
        Rear Side Buckle Light Rear seat belt buckle light OFF or ON w/o Rear Power Seat System
        Fr Foot Light Interior illumination light assembly (footwell light) OFF or ON -
        Relay for Interior Light Auto Cut Function DOME CUT D relay OFF or ON

        When performing this active test, turn all the interior lights on.


        • OFF: DOME CUT D relay on (interior lights turn on)

        • ON: DOME CUT D relay off (interior lights turn off)
        Interior Illumination Light2 Multi-display (interior illumination light assembly) OFF or ON

        Preconditions for using the Active Test to check dimmer controlled illumination:


        • Power switch on (READY).

        • Shift lever is in any position other than P.
        Dimmer Signal Outputs night mode (dimmer signal) OFF or ON -








      • *: Refer to Operation Check for the lights that are controlled by the illuminated entry system.

        Click here


      1. Body Electrical > Front Left Door > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Inside Handle Light Front door trim board sub-assembly LH (front door inside handle illumination) ON or OFF -
        Door Illumination 1 Front door trim board sub-assembly LH (ornament illumination) ON or OFF -
        Door Illumination 2 Front door trim board sub-assembly LH (armrest illumination) ON or OFF -





      1. Body Electrical > Front Right Door > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Inside Handle Light Front door trim board sub-assembly RH (front door inside handle illumination) ON or OFF -
        Door Illumination 1 Front door trim board sub-assembly RH (ornament illumination) ON or OFF -
        Door Illumination 2 Front door trim board sub-assembly RH (armrest illumination) ON or OFF -





      1. Body Electrical > Rear Left Door > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Inside Handle Illumination Rear door trim board sub-assembly LH (rear door inside handle illumination) ON or OFF -
        Door Illumination 1 Rear door trim board sub-assembly LH (ornament illumination) ON or OFF -
        Door Illumination 2 Rear door trim board sub-assembly LH (armrest illumination) ON or OFF -





      1. Body Electrical > Rear Right Door > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Inside Handle Illumination Rear door trim board sub-assembly RH (rear door inside handle illumination) ON or OFF -
        Door Illumination 1 Rear door trim board sub-assembly RH (ornament illumination) ON or OFF -
        Door Illumination 2 Rear door trim board sub-assembly RH (armrest illumination) ON or OFF -





      1. Body Electrical > Rear Left Seat > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Buckle Lighting Rear seat belt buckle light OFF or ON w/ Rear Power Seat System



      1. Body Electrical > Rear Right Seat > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Buckle Lighting Rear seat belt buckle light OFF or ON w/ Rear Power Seat System



      1. Body Electrical > Entry&Start > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Power/Engine SW Light Power switch illumination OFF or ON -