Click here

CAN COMMUNICATION SYSTEM Open in One Side of Bus 4 Branch Line

Click here
Click here
DTC Code DTC Name
  Open in One Side of Bus 4 Branch Line
Click here

DESCRIPTION

When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes intermittently, an open in one of the wires of a CAN bus branch line is suspected.

Tip:

If there is an ECU or sensor whose connection status changes intermittently while checking the "Communication Bus Check" screen, there may be an open circuit in one of the wires of a branch line of an ECU or sensor in the bus. If an open occurs in one of the wires of a CAN branch line, it may interfere with the communication of other ECUs or sensors resulting in an incorrect state being displayed.

Symptom Trouble Area
There is an ECU or sensor that is indicated as not communicating on the "Communication Bus Check" screen or whose connection status on the "Communication Bus Check" screen changes intermittently.

One side of CAN branch wire is open, or output signals are incomplete.


  • Steering sensor

  • Rack and pinion power steering gear assembly

  • Airbag ECU assembly

  • ECM

  • Yaw rate sensor

  • Skid control ECU assembly

  • Hybrid vehicle control ECU assembly

  • Pedestrian detection ECU assembly

  • Rear steering control ECU*1

  • Parking brake ECU assembly

  • Absorber control ECU

  • Suspension control ECU*2

  • Tire pressure warning ECU and receiver

  • Front steering control ECU*3

  • Occupant Detection ECU*4

*1: w/ Dynamic Rear Steering System *2: w/ Air Suspension System *3: w/ Variable Gear Ratio Steering System *4: w/ Occupant Classification System
Click here

CAUTION / NOTICE / HINT

CAUTION:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.

Note:
  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

    Click here

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.

    DTC check procedure: Turn the power switch on (IG) and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.

  • After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.

    Click here

  • Some parts must be initialized and set when replacing or removing and installing parts.

    Click here

Click here

PROCEDURE


  1. Click here

    CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE


    1. Based on the vehicle equipment and specifications, confirm the systems that use CAN communication.

      Click here

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Using the GTS, perform "CAN Bus Check".

      Click here


      1. CAN Bus Check

    6. Observe the screen for approximately 2 minutes to check for ECUs and sensors that are displayed as not communicating.

    7. Perform the inspection as specified in the Problem Symptoms Table for the ECUs or sensors that are not communicating.

      Result
      Proceed to
      NEXT

    • NEXT

      GO TO CORRESPONDING COMMUNICATION STOP MODEClick here