WIPER AND WASHER SYSTEM FREEZE FRAME DATA

FREEZE FRAME DATA

1. Whenever a DTC is detected, the windshield wiper motor assembly stores the current vehicle state as Freeze Frame Data.

CHECK FREEZE FRAME DATA

1. Turn the power switch off.

2. Connect the GTS to the DLC3.

3. Turn the power switch on (IG).

4. Turn the GTS on.

5. Enter the following menus: Body Electrical / Wiper / Trouble Codes.

   
   
   1. Body Electrical > Wiper > Trouble Codes
   2. 
      
   3. 
      
   
   
   1. Body Electrical > Wiper

      Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
      Wiper Switch HI (Line)	Windshield wiper switch assembly HI signal (abnormal control system) input condition	OFF or ON	OFF: Windshield wiper switch assembly not in HI position ON: Windshield wiper switch assembly in HI position	-
      Wiper Stop Position	Displays windshield wiper motor assembly stop position	Store Are, Lower Rev Pos, Wipe Area or Upper Rev Pos	Store Are/Lower Rev Pos: Lower reverse position or lower Lower Rev Pos: Lower reverse position or lower reverse position or less Wipe Area: Between lower reverse position and upper reverse position Upper Rev Pos: Upper reverse position	-
      Wiper Position	Displays the wiper position	Store Are, Exchange Position or Wipe Area	Store Area: Lower reverse position Exchange Position: Service position Wipe Area: Lower reverse position higher or upper reverse position or less	-
      Status of Motor Lock	Windshield wiper motor assembly stuck malfunction condition	Normal or Lock	Normal: Normal operation possible Lock: Operation unavailable	-
      Status of Temperature Protection	Condition of temperature protection control for the windshield wiper motor assembly	Normal, LO Operation, INT Operation or Stop	Normal: Motor temperature less than 95°C (203°F) LO Operation: Motor temperature 95°C (203°F) or more INT Operation: Motor temperature 100°C (212°F) or more Stop: Motor temperature 105°C (221°F) or more	-
      Status of Overvoltage	Windshield wiper motor assembly voltage condition	Normal or Overvoltage	Normal: Normal operation possible Overvoltage: Operation unavailable	-
      Status of Low Voltage	Windshield wiper motor assembly voltage condition	Normal or Low Voltage	Normal: Normal operation possible Low Voltage: Operation unavailable	-
      Motor Shaft Angle	Displays windshield wiper motor assembly rotation angle	0 to 255 °	Displays windshield wiper motor assembly rotation angle	Tip: Upper reverse position: 159.3° Retracted position or lower than the retracted position: 0°
      Motor Temperature	Displays windshield wiper motor assembly internal temperature sensor value	Min.: -128°C (-262°F), Max.: 128°C (262°F)	Displays windshield wiper motor assembly internal temperature sensor value	-
      Motor Current	Displays windshield wiper motor assembly current	0 to 63 A	Displays windshield wiper motor assembly current	-
      Motor Power Supply Voltage	Displays windshield wiper motor assembly voltage	0 to 63 V	Displays windshield wiper motor assembly voltage	-
      Number of DTCs	Number of trouble codes	0 to 255	Number of stored DTCs displayed	-

   2. 
      
      10. 
          
      11. 
          
      12. 
          
      13. 
          
      14. 
          
      15. 
          
      16. 
          
      17. 
          
      18. 
          
      19. 
          
      20. 
          
      21.