Click here

PANORAMIC VIEW MONITOR SWITCH INSPECTION

Click here
Click here

PROCEDURE


  1. Click here

    INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (for LHD)


    1. Remove the integration control and panel assembly (panoramic view monitor switch).

      Click here

    2. B004SLSC08
      *a

      Component without harness connected

      (Integration Control and Panel Assembly (Panoramic View Monitor Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      G5-5 (D) - G5-17 (E) Panoramic view monitor switch on (not protruding) Below 1 Ω
      Panoramic view monitor switch off (protruding) 10k Ω or higher

      If the result is not as specified, replace the integration control and panel assembly (panoramic view monitor switch).

    3. B004TEVC06
      *a

      Component without harness connected

      (Integration Control and Panel Assembly (Panoramic View Monitor Switch))

      Check the illumination.


      1. Apply auxiliary battery voltage to the connector and check the illumination conditions.

        OK
        Battery Connection Specified Condition

        G5-8 (ILL+) - Auxiliary Battery positive (+)

        G5-15 (ILL-) - Auxiliary Battery negative (-)

        		 Illuminates

        If the result is not as specified, replace the integration control and panel assembly (panoramic view monitor switch).

    4. Install the integration control and panel assembly (panoramic view monitor switch).

      Click here

  2. Click here

    INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (for RHD)


    1. Remove the integration control and panel assembly (panoramic view monitor switch).

      Click here

    2. B004UBXC13
      *a

      Component without harness connected

      (Integration Control and Panel Assembly (Panoramic View Monitor Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      G5-6 (D) - G5-18 (E) Panoramic view monitor switch on (not protruding) Below 1 Ω
      Panoramic view monitor switch off (protruding) 10k Ω or higher

      If the result is not as specified, replace the integration control and panel assembly (panoramic view monitor switch).

    3. B004SYGC09
      *a

      Component without harness connected

      (Integration Control and Panel Assembly (Panoramic View Monitor Switch))

      Check the illumination.


      1. Apply auxiliary battery voltage to the connector and check the illumination conditions.

        OK
        Battery Connection Specified Condition

        G5-8 (ILL+) - Auxiliary Battery positive (+)

        G5-15 (ILL-) - Auxiliary Battery negative (-)

        		 Illuminates

        If the result is not as specified, replace the integration control and panel assembly (panoramic view monitor switch).

    4. Install the integration control and panel assembly (panoramic view monitor switch).

      Click here