CLEARANCE WARNING ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the clearance warning ECU assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link

    w/ Parking Support Brake System

  • Clearance warning ECU assembly

  • Ultrasonic sensor detection angle

  • Steering angle neutral point

  • Registration of bumper type

  • Ultrasonic sensor detection angle registration

  • Parking support alert system

  • Parking support brake system

Click here


    w/o Parking Support Brake System

  • Clearance warning ECU assembly

 Registration of bumper type Parking support alert system

Click here

When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate

Click here

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

    B004RGLC03
    B004RMI Remove in this Direction

    1. Detach the pin.

    2. Lift up the strap and remove the luggage compartment trim cover RH.

  2. REMOVE SIDE TRIM BOX

    B004XSUC02
    B004V32 Place Hands Here
    B004RMI Remove in this Direction (1)
    B004T3S Remove in this Direction (2)

    1. Place your hand at the position shown in the illustration and detach the claw.

    2. Detach the guide and remove the side trim box the direction of the arrow shown in the illustration.

  3. REMOVE CLEARANCE WARNING ECU ASSEMBLY


    1. B004YFQC03
      B004SZX Connector
      B004UK4 Nut

      Disconnect the connector.

    2. Remove the nut.

      Note

      If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

      B004VS8

    3. Detach the guide and remove the clearance warning ECU assembly.