Click here

PARKING ASSIST MONITOR SYSTEM Reverse Signal Circuit

Click here
Click here
DTC Code DTC Name
  Reverse Signal Circuit
Click here

DESCRIPTION

The multi-display receives a reverse signal from the No. 3 semiconductor power integration ECU.

Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

Click here

PROCEDURE


  1. Click here

    CHECK BACK-UP LIGHT


    1. Check that the back-up light comes on.

      OK
      The back-up light comes on.
      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)


    1. B004UXRC37
      *a

      Front view of wire harness connector

      (to Multi-display)

      Disconnect the multi-display connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G51-3 (REV) - Body ground

      Power switch on (READY)

      Shift position in R

      		 7.25 to 14.65 V
      G51-3 (REV) - Body ground

      Power switch on (READY)

      Shift position not in R

      		 Below 1 V
      Result
      Proceed to
      OK
      NG

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR