Note
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Tech Tips
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | Link |
|---|---|---|
| System does not operate at all | CAN communication system | Click here |
| Meter / gauge system | Click here | |
| Proceed to "Power Source Circuit" | ||
| Steering pad switch assembly | ||
| Spiral with sensor cable sub-assembly | ||
| Blind spot monitor sensor RH | ||
| System cannot be turned off | CAN communication system | |
| Meter / gauge system | Click here | |
| Steering pad switch assembly | ||
| Spiral with sensor cable sub-assembly | ||
| Blind spot monitor sensor RH | ||
| "BSM Not Available" or "BSM Malfunction Visit Your Dealer" is displayed on the multi-information display | Check abnormality history | |
| Blind spot monitor sensor LH | ||
| Blind spot monitor sensor RH | ||
| Combination meter assembly |
| Symptom | Suspected Area | Link |
|---|---|---|
| Outer rear view mirror indicator RH does not illuminate | Proceed to "Blind Spot Monitor Beam Axis Confirmation" | |
| Outer mirror RH (outer rear view mirror indicator RH) | ||
| Front multiplex network door ECU RH | ||
| Outer mirror actuator assembly RH | ||
| Blind spot monitor sensor RH | ||
| Outer rear view mirror indicator LH does not illuminate | Proceed to "Blind Spot Monitor Beam Axis Confirmation" | |
| Outer mirror LH (outer rear view mirror indicator LH) | ||
| Front multiplex network door ECU LH | ||
| Outer mirror actuator assembly LH | ||
| Blind spot monitor sensor LH | ||
| Outer rear view mirror indicator RH remains illuminated | Proceed to "Blind Spot Monitor Beam Axis Confirmation" | |
| Blind spot monitor sensor RH | ||
| Outer rear view mirror indicator LH remains illuminated | Proceed to "Blind Spot Monitor Beam Axis Confirmation" | |
| Blind spot monitor sensor LH | ||
| Outer rear view mirror indicator RH does not flash | Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section | |
| Blind spot monitor sensor RH | ||
| Outer rear view mirror indicator LH does not flash | Proceed to "Turn Signal Light" in Problem Symptoms Table for the Lighting (EXT) section | |
| Blind spot monitor sensor LH | ||
| Outer rear view mirror indicator RH continues to flash | Blind spot monitor sensor RH | |
| Outer rear view mirror indicator LH continues to flash | Blind spot monitor sensor LH |
| Symptom | Suspected Area | Link |
|---|---|---|
| The proximity warning function for vehicles to the rear does not operate | Meter / gauge system | |
| Perform Active Test (Activate the FHL) | ||
| Harness or connector | - | |
| Combination meter assembly | ||
| Blind spot monitor sensor LH | ||
| Blind spot monitor sensor RH | ||
| "FHL Not Available" or "FHL Malfunction Visit Your Dealer" is displayed on the multi-information display in the combination meter assembly | Check abnormality history | |
| Blind spot monitor sensor LH | ||
| Blind spot monitor sensor RH | ||
| Combination meter assembly |