Click here

STEERING WHEEL INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Note:

  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY

    Click here

  2. Click here

    INSTALL NO. 1 STEERING WHEEL ORNAMENT


    1. B004TNU

      Engage the gaide pin to install the No .1 steering wheel ornament.

    2. Install the 2 screws.

  3. Click here

    INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  4. Click here

    ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  5. Click here

    INSPECT AND ADJUST SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Click here

  6. Click here

    INSTALL STEERING WHEEL ASSEMBLY


    1. B004VVMC01
      *a Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.

      62 N*m 632 kgf*cm 46 ft.*lbf

    3. Connect the connectors to the steering wheel heater control assembly.

    4. Connect each connector to the spiral cable with sensor sub-assembly.

  7. Click here

    CHECK STEERING WHEEL CENTER POINT

  8. Click here

    INSTALL HORN BUTTON ASSEMBLY

    Click here

  9. Click here

    PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION (w/ VGRS)

    Click here