STEERING PAD SWITCH INSPECTION

PROCEDURE


  1. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Measure the resistance according to the value(s) in the table below.

      B004TC2C02
      *1 Up *2 Down
      *3 Left *4 Right
      *5 Enter *6 Back
      *7 Tel *8 Voice
      *9 Volume+ *10 Volume-
      *11 Main *12 Cancel
      *13 Seek+ *14 Seek-
      *15 MODE *16 +RES
      *17 -SET *18 Distance Control
      *19 Lane Departure Alert Main - -
      *a

      Component without harness connected

      (Steering Pad Switch Assembly)

      		 - -
      Standard Resistance
      Tester Connection Condition Specified Condition
      z6-3(AU1) -z6-10(EAU) No switch pushed 95 to 105 kΩ
      Seek+ switch pushed Below 2.5 Ω
      Seek- switch pushed 312 to 345 Ω
      Volume+ switch pushed 950 to 1050 Ω
      Volume- switch pushed 2954 to 3265 Ω
      z6-9(AU2) - z6-10(EAU) No switch pushed 95 to 105 kΩ
      MODE switch pushed Below 2.5 Ω
      Tel switch pushed 950 to 1050 Ω
      Voice switch pushed 2954 to 3265 Ω
      z6-5(+DP2) - z6-10(EAU) No switch pushed 95 to 105 kΩ
      Left switch pushed Below 2.5 Ω
      Up switch pushed 312 to 345 Ω
      Down switch pushed 950 to 1050 Ω
      Right switch pushed 2954 to 3265 Ω
      z6-4(+DP) - z6-10(EAU) No switch pushed 95 to 105 kΩ
      Enter switch pushed Below 2.5 Ω
      Back switch pushed 312 to 345 Ω
      z6-8(DIST) - z6-12(ECC) No switch pushed 1 MΩ or higher
      Distance control switch pushed Below 2.5 Ω
      Lane departure alert main switch pushed 228 to 252 Ω
      z6-2(CCS) - z6-12(ECC) No switch pushed 1 MΩ or higher
      Main switch pushed Below 2.5 Ω
      Cancel switch pushed 235 to 244 Ω
      +RES switch pushed 617 to 642 Ω
      -SET switch pushed 1509 to 1570 Ω
      z6-11(GND1) - A-1(VGRS) Always Below 2.5 Ω

      Tech Tips

      If the result is not as specified, replace the steering pad switch assembly.

    2. Check the illumination.


      1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the steering pad switch assembly.

        Standard
        Measurement Condition Specified Condition
        Battery positive (+) → z6-1 (IL+2) Battery negative (-) → z6-6 (ILL-) Illuminates

        Tech Tips

        If the result is not as specified, replace the steering pad switch assembly.