DYNAMIC REAR STEERING SYSTEM TEST MODE PROCEDURE

TEST MODE

1. Activate Test Mode.

   
   

   1. Turn the power switch off.

   2. Connect the GTS to the DLC3.

   3. Turn the power switch on (IG).

   4. Turn the GTS on.

   5. Enter the following menus: Chassis / DRS / Utility / Check Mode.

      
      
      1. Chassis > DRS > Utility

         Tester Display
         Check Mode

      2. 
         
         1. 
            
      3. 
         
         10. 
             

2. Check the Test Mode display.

   
   

   1. Check that "DRS TEST MODE" is displayed on the multi-information display when the system enters Test Mode.

3. End Test Mode.

   
   

   1. Switch the system from test mode to normal mode by following the directions on the GTS screen.

   2. Turn the power switch off.

   3. Disconnect the GTS to the DLC3.