REAR BRAKE(for 4-Pot Caliper)

Click here

CAUTION / NOTICE / HINT

Tip:

Use the same procedure for the RH and LH sides, except where indicated.
The following procedure is for the LH side.

Click here

PROCEDURE

Click here
INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM

Click here
Click here
INSTALL REAR DISC BRAKE PAD

Click here
Click here
INSTALL REAR DISC LH
1. Check the identification mark to determine the installation side.
  
  Note:
  The rear disc needs to be installed to the correct side of the vehicle. There is a "L", indicating the disc for the left wheel, or a "R", indicating the disc for the right wheel, engraved on the disc in the position shown in the illustration.
2. When reusing the rear disc LH:
  1. *a Matchmark
    
    Align the matchmarks of the rear disc and rear axle hub and bearing assembly LH, and install the rear disc LH.
3. When replacing the rear disc LH:
  1. Inspect the rear disc runout.
    
    Click here
  2. Select the installation position where the rear disc has minimal runout, and install the rear disc LH.
4. Temporarily install the 5 hub nuts.
Click here
INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
1. Install the parking brake shoe adjusting hole plug to rear disc LH.
Click here
INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH
1. Install the rear disc brake cylinder assembly LH to the rear axle carrier sub-assembly LH with the 2 bolts.
  
  151 N*m 1540 kgf*cm 111 ft.*lbf
Click here
CONNECT REAR FLEXIBLE HOSE
1. Connect the rear flexible hose to the rear disc brake cylinder assembly LH with a new union bolt and a new gasket.
  
  39.2 N*m 400 kgf*cm 29 ft.*lbf
  
  Note:
  Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly LH.
Click here
CONNECT BRAKE BOOSTER PUMP CONNECTOR

Click here
Click here
BLEED BRAKE LINE

Click here
Click here
ADJUST PARKING BRAKE

Click here
Click here
INSTALL REAR WHEEL

Click here
Click here
PARKING BRAKE SHOE BEDDING

Click here

REAR BRAKE(for 4-Pot Caliper) INSTALLATION