Click here

REAR BRAKE(for 4-Pot Caliper) REASSEMBLY

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG

    Tip:

    Tighten the rear disc brake bleeder plug after bleeding the system.

  2. Click here

    INSTALL PISTON SEAL


    1. B004TBCC05
      B004VGX Lithium soap base glycol grease

      Apply lithium soap base glycol grease to the entire circumference of 4 new piston seals.

    2. B004W4P

      Install the 4 piston seals to the rear disc brake cylinder assembly LH.

      Note:

      Securely install the piston seal into the groove of the rear disc brake cylinder assembly LH.

  3. Click here

    INSTALL REAR DISC BRAKE PISTON


    1. B004RCYC01
      *1 Cylinder Boot
      *2 Rear Disc Brake Piston
      B004VGX Lithium soap base glycol grease

      Apply a light layer of lithium soap base glycol grease to the entire circumference of 4 new cylinder boots.

    2. Install the 4 cylinder boots to the rear disc brake pistons.

      Note:

      Securely install the cylinder boot into the groove of the rear disc brake piston.

    3. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake pistons, and install it to the rear disc brake cylinder assembly LH.

      Note:

      Do not forcibly install the rear disc brake piston into the rear disc brake cylinder assembly LH.

  4. Click here

    INSTALL CYLINDER BOOT


    1. B004TUHC01
      *1 Cylinder Boot
      *2 Rear Disc Brake Piston
      *3 Rear Disc Brake Cylinder Assembly LH

      Install the 4 cylinder boots to the rear disc brake cylinder assembly LH as shown in the illustration.

      Note:

      • Securely install the cylinder boot into the groove of the rear disc brake cylinder assembly LH and rear disc brake piston.

      • Do not damage the cylinder boot.