Click here

REAR BRAKE(for 4-Pot Caliper) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear brake removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Rear disc (Including removal and installation) Parking brake bedding Electric parking brake system

Click here
Note:

  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to remove the brake booster pump connectors before beginning work.

Tip:

  • Use the same procedure for the RH and LH sides, except where indicated.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  2. Click here

    REMOVE REAR WHEEL

    Click here

  3. Click here

    DRAIN BRAKE FLUID

    Note:

    If brake fluid leaks onto any painted surface, immediately wash it off.

  4. Click here

    REMOVE REAR DISC BRAKE PAD

    Click here

  5. Click here

    REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM

    Click here

  6. Click here

    DISCONNECT REAR FLEXIBLE HOSE


    1. B004SP2

      Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly LH.

  7. Click here

    REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. B004XR7

      Remove the 2 bolts and rear disc brake cylinder assembly LH from the rear axle carrier sub-assembly LH.

  8. Click here

    REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG


    1. Remove the parking brake shoe adjusting hole plug from the rear disc LH.

  9. Click here

    REMOVE REAR DISC LH


    1. B004TV6C01
      *a Matchmark

      Put matchmarks on the rear disc LH and the rear axle hub and bearing assembly LH.

      Tip:

      Not required when replacing the rear disc LH.

    2. B004WCJC01
      B004RMI Contract

      Release the parking brake and remove the rear disc LH.

      Tip:

      If the rear disc LH cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.