Click here

BRAKE BOOSTER PUMP REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake booster pump assembly removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Stereo Camera type:Click here

for Mono Camera type:Click here
Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Stereo camera type)
Pre-collision system (for Mono camera type)
Adaptive high beam system

  • Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here
Parking assist monitor system

Click here
Panoramic view monitor system

Click here
Initialize rear door sunshade system Rear door sunshade system

Click here
Initialize power trunk lid system Power trunk lid system

Click here
Brake pedal support assembly (Including removal and installation)

  • Clear stored linear solenoid valve calibration data

  • Perform initialization and calibration of the linear solenoid valve

  • DTCs are stored

  • ABS warning light illuminates

  • Brake warning light/yellow (minor malfunction) illuminates

  • Slip indicator light illuminates

  • VSC disabled or malfunctions

for Initialization:Click here

for Calibration:Click here
Brake actuator assembly (Including removal and installation)

  • Bleed air

  • Clear stored linear solenoid valve calibration data

  • Perform initialization and calibration of the linear solenoid valve
*: When performing learning using the GTS. Click hereClick here
Click here

CAUTION / NOTICE / HINT

Note:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    REMOVE BRAKE MASTER WITH STROKE SIMULATOR CYLINDER ASSEMBLY

    Click here

  2. Click here

    REMOVE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY

    Click here