FRONT SPEED SENSOR(for AWD)

CAUTION / NOTICE / HINT

Note:

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

Tip:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

Click here

PROCEDURE

Click here
INSTALL FRONT SKID CONTROL SENSOR WIRE
1. for LH Side:
  1. Install the sensor clamp with the bolt.
    
    10 N*m 102 kgf*cm 7 ft.*lbf
    
    Note:
    Do not twist the skid control sensor wire when installing it.
  2. Install the speed sensor with the bolt.
    
    8.5 N*m 87 kgf*cm 75 in.*lbf
    Note:
    - Prevent foreign matter from attaching to the front speed sensor tip.
    - Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.
2. for RH Side:
  1. Install the sensor clamp with the bolt.
    
    10 N*m 102 kgf*cm 7 ft.*lbf
    
    Note:
    Do not twist the skid control sensor wire when installing it.
  2. Connect the skid control sensor wire connector.
    
    8.5 N*m 87 kgf*cm 6 ft.*lbf
    Note:
    - Prevent foreign matter from attaching to the front speed sensor tip.
    - Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.
  3. Connect the pad wear indicator connector.
3. Install the sensor clamp with the nut.
  
  8.5 N*m 87 kgf*cm 75 in.*lbf
  
  Note:
  Do not twist the skid control sensor wire when installing it.
4. Install the sensor clamp with the bolt.
  
  8.5 N*m 87 kgf*cm 75 in.*lbf
  
  Note:
  Do not twist the skid control sensor wire when installing it.
5. Connect the clamp.
6. Connect the skid control sensor wire connector.
Click here
INSTALL FRONT WHEEL

Click here
Click here
CHECK FOR SPEED SENSOR SIGNAL

Click here

FRONT SPEED SENSOR(for AWD) INSTALLATION