FRONT SPEED SENSOR(for AWD) REMOVAL

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. REMOVE FRONT SKID CONTROL SENSOR WIRE


    1. B004WDT

      Disconnect the front skid control sensor wire connector.

    2. Remove the bolt and sensor clamp.

    3. Disconnect the clamp.

    4. B004WAG

      Remove the nut and sensor clamp.

    5. B004VXD

      for LH Side:


      1. Remove the bolt and speed sensor.

      2. Remove the bolt and sensor clamp.

    6. B004SPU

      for RH Side:


      1. Disconnect the pad wear indicator connector.

      2. Remove the bolt and speed sensor.

      3. Remove the bolt and sensor clamp.