FRONT SPEED SENSOR(for 2WD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Install the front axle hub sub-assembly LH.

      Click here

      Tech Tips

      The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor malfunctions, replace the front axle hub sub-assembly.

  2. INSTALL FRONT DISC LH

    Click here

  3. CONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  4. INSTALL SKID CONTROL SENSOR WIRE


    1. B004RWJ

      for LH Side:


      1. Install the sensor clamp with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note

        Do not twist the skid control sensor wire when installing it.

      2. Connect the skid control sensor wire connector.

    2. B004V3L

      for RH Side:


      1. Install the sensor clamp with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note

        Do not twist the skid control sensor wire when installing it.

      2. Connect the skid control sensor wire connector.

      3. Connect the pad wear indicator connector.

    3. B004S23

      Install the sensor clamp with the nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    4. B004X17

      Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the skid control sensor wire when installing it.

    5. Connect the skid control sensor wire connector.

  5. INSTALL FRONT WHEEL

    Click here

  6. CONNECT BRAKE BOOSTER PUMP CONNECTOR


    1. With the engine switch off, connect the 2 brake booster pump connectors.

    2. Clear the DTCs.

      Click here

  7. CHECK FOR SPEED SENSOR SIGNAL

    Click here