Click here

FRONT SPEED SENSOR(for 2WD) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

Click here

PROCEDURE


  1. Click here

    DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  2. Click here

    REMOVE FRONT WHEEL

    Click here

  3. Click here

    REMOVE SKID CONTROL SENSOR WIRE


    1. B004X17

      Disconnect the front skid control sensor wire connector.

    2. Remove the bolt and sensor clamp.

    3. B004S23

      Remove the nut and sensor clamp.

    4. B004RWJ

      for LH Side:


      1. Disconnect the front skid control sensor wire connector.

      2. Remove the bolt and sensor clamp.

    5. B004V3L

      for RH Side:


      1. Disconnect the pad wear indicator connector.

      2. Disconnect the front skid control sensor wire connector.

      3. Remove the bolt and sensor clamp.

  4. Click here

    DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  5. Click here

    REMOVE FRONT DISC LH

    Click here

  6. Click here

    REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Remove the front axle hub sub-assembly LH.

      Click here

      Tip:

      The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor malfunctions, replace the front axle hub sub-assembly.